solder dross recycling machine used in the PCB electronic industry,it is designed to recover pure tin and solder dross from working impurities oxides generated from the wave soldering with lead or lead free process.This tin slag recycling machine not only provides a considerable savings cost,but has the added benefit of being right in your own manufacturing environment.
Activates the specific weight of the materials that have to be separated by solder dross recycle system.before the first time use the tin slag recovery machine,we need disassembly the top device of solder recycling equipment and then put in 20kg of tin bar inside the solder recycling machine. And then reinstall the top device.when the solder dross recycling machine working,the solder dross separator will turns the tin bar into liquid tin.after the tin slag is filtered by the solder dross separation device process,the reusable alloy settles in the lower section of the pot while the dross floats on the surface.The reusable have identical characteristic to the present alloy captured in the solder pot.
solder dross recycling machineonline automatic solder dross separation machine
The solder dross recycling equipment will automate output the solder dross ash to the junk the meantime,store the separated tin in the material receiving box.Once the material receiving box is full,the solder recycle machine waste extract system will alarm and stop working until the operator come and release the tin.Once the operator open the discharge knob,the tin will flow to the bottom tin box,you need manual close the discharge knob if the tin box is full and wait the next release.after ten minute,the liquid tin in the tin box will curdle until became the tin bar.the solder dross recycling equipment finish the whole solder dross recycling and then the operator can take the tin bar to the wave soldering machine for reuse.
solder dross recovery machineLead Free Solder Dross Recycle Machine
The accessories list as following:
1)2 pieces of tin box(use for replace when using)
2)2 pieces of junk box(use for replace when using)
3)1 pieces of screw rob(use for turn the discharge knob)
SMT solder dross recovery equipment systems video manual:
Step1:Disassembly the top device of solder recycling equipment and put in 20kg of tin bar inside the solder recycling machine.
Please check this video link to see the operation:
Step 2: Reinstall the top device 
Please check this video link to see the operation:
Step 3: About how to use this ASCEN solder dross recycling equipment to separator your tin slag 
Please check the video link to see how to set this solder dross separator:
Step 4: About the field use demonstration of tin slag recovery machine: